Custom firmware request - 6i25, 7i76

Hi,

We are using the 6i25 and 7i26 to drive some steppers but would like to also control external devices with PWM signals.

Rather than the usual 5 stepper outputs, we would like just 2 stepper outputs and 2 PWM outputs in place of the other stepper outputs, is this possible and if so could someone to generate custom firmware for us?

Thanks!

5I25/6I25 bitfile for 1 or 2X 7I76, each with 3 Step/Dir and 2 PWM/Dir:

 

 

52 minutes !!!
It took 52 minutes to have custom firmware, so i have to say this again:

--The best support on earth, bar none !--

Thank you, PCW.
P.S.
Not my request, but i did request several time custom firmware, always the same result as above.
Try asking for custom firmware from any other company ....

Amazing, thanks for such a quick response!!