Mesa 7i92M+7i85+7i78 'hm2_7i92.0.dpll.01.timer-us' not found

Hi,
I've read quite a lot of forum posts lately. But my Problem seems to be a bit more specific.

I've got a 7i92 and connected a 7i78 on P1 and a 7i85 on P2 and uploaded a self compiled firmware.

I commented in the lines: and compiled to get the firmware for my configuration.

I ran the PncConf to get a basic configuration that works... Except one error: When I try to run LinuxCNC it exits with an error. After using google I found out that the DPLL timer (that is necessary/recommended for Ethernet cards) must somehow be enabled in Code, But I've got no idea where and how to do that.

I also attached some files just in case. It would be great if someone could give me a hint on how to do that. 

Moved to "driver boards"

You would need to edit the PIN_7I85S_7I78_34.vhd file and add the module ID
information for the DPLL. You can look at a pinout file with a  D_34 at the end
as an example (say PIN_G540x2D_34.vhd) as these have the DPLL module
included.

Thanks alot, it compiled round about one hour because its just below the limit, but it worked so far.