7i76E Stock ?

and gone. I guess we wont see anymore 7i76E's until the new design comes out.

What happened?

MESA sold out of them again. The FPGA that the board has been designed with is extremely
expensive now and from what I understand a replacement board is in the works with a different
FPGA chip.

Did you get some a few days back?
You wanted more?
I am getting low on Mesa also, and since we are here, PCW, is there a firmware for 7i95 with 7i77? I do not need it right now, but i might have to return the 7i92 to the machine i borrowed it from.

Yes. I got the 2 ordered that I needed plus 2 more for a couple other machines I have my eye on.
Though once I have the two 7i76E's installed in their respective machines I will have two 7i96
NON S versions that I most likely wont need anymore. This Linuxcnc stuff is an addiction.

my1987toyota wrote:

This Linuxcnc stuff is an addiction.

People collect old strange paintings, i collect Mesa boards!
And right now i really really need a 7i72, like right now, not after a month. By then i will cobble together some 30 odd inverted outputs!

my1987toyota wrote:

Yes. I got the 2 ordered that I needed plus 2 more for a couple other machines I have my eye on.
 

or at least I thought I had got two more ordered before they ran out. I had been so busy at work that
I didn't check my email for a few days ( long days too tired ). It was only Later that I found out the 2nd
order got canceled because I didn't confirm in time. Unfortunately Mesa is not going to have the
7i76E in stock until the new design is out.

Hey Tommylight I see EUsurplus has some 7i72's in stock. I am not sure if customs would be
the limiting factor time wise.

I did not bother to check, currently i am totally broke, and i caused plenty of work for eusurplus last order as it was returned to sender so they had to mail it again in two boxes. They are very, very good so i try not to bother them.
I already started making some inverters as i had over 40 of 2N2222 transistors, but i have only 14 of 2.7KOhm resistors, sooo.....
More diving through the shop !

that and a nice piece of perf-board.