7i96 - P1 CONNECTOR - 15 mA for sink - it is not good

OK

OK its R38

It looks like it was a deliberate change to allow better operation with G540 drives (that need more high drive on the charge pump signal = DB25 pin16 =GPIO50)

I will fix the documentation

This is my R38. 
 

I have an application where I use a 7I37TA card to protect P1. Will this resistor not bother her?

PCW wrote:

OK its R38

It looks like it was a deliberate change to allow better operation with G540 drives (that need more high drive on the charge pump signal = DB25 pin16 =GPIO50)

I will fix the documentation
 

It si not DB25 pin16. It is lucky 13.
 

OK
It should not interfere with any Mesa daughter card but might cause issues
with some parallel port BOBs

I checked the BOM and its 300 Ohms there, not sure if it was done for a reason
or was just a mistake.