Trinamic TMCM-351 as a CNC controller & driver

Hi there, 

I recently got give an Trinamic TMCM-351 motor controller and driver module and was hopeful it would be possible to use it as a CNC controller with something like LinuxCNC.

Does anyone have experience with Trinamic motion controllers and LinuxCNC?
 

not supported by linuxcnc...
For linuxcnc look something from mesa hardware or other compatible hardware.
But for simple steppers if you have low jitter will work the parallel port with cheap 5axis bob.

Aww shucks, seemed like a good board.
Im sure it will get use on some project sometime.

I guess Ill go for the MESA 7C80 or 7C81 RPI