7i92T and 7i95T on LinuxCNC 2.9

John the buildbot gets 2.10 if you change the sources.list if you replace the  line with 2.9 uspace with master-uspace in the sources.list eg.
deb buildbot2.highlab.com/debian/ bookworm master-uspace 
You can also navigate to the debs and install the debs manually in that case I have done
sudo apt remove linucnc-uspace linuxcnc-uspace-dev
Then manually install the downloaded packages
sudo dpkg -i  linuxcnc-uspace(tab)
sudo dpkg -i linuxcnc-uspace-dev(tab)

Peter added support for the 7i95T to 2.9 so I need to pull and build that to test. I "think" Andy also fixed the open gl error last night as well as the M4 issue.

JT

JT wrote:

Peter added support for the 7i95T to 2.9 so I need to pull and build that to test. I "think" Andy also fixed the open gl error last night as well as the M4 issue.

JT

Yes, andy backported the fix for opengl to 2.9 yesterday
I have rebuilt my installer
drive.google.com/file/d/1s2Te9JtXxb8yB9r.../view?usp=drive_link
but that does not really matter becasue on an apt updade && apt upgrade it will get the latest lcnc version from the buildbot

rodw wrote:

JT wrote:

Peter added support for the 7i95T to 2.9 so I need to pull and build that to test. I "think" Andy also fixed the open gl error last night as well as the M4 issue.

JT
Yes, andy backported the fix for opengl to 2.9 yesterday
I have rebuilt my installer
drive.google.com/file/d/1s2Te9JtXxb8yB9r.../view?usp=drive_link
but that does not really matter becasue on an apt updade && apt upgrade it will get the latest lcnc version from the buildbot
 

Tested 2.9 and 2.10 and both work almost. Looks like a pin has been removed in 2.10 but the sim's have not been updated so they fail to run. But NO opengl errors!

JT

Great.
What pin is missing and what sim?

A pin with "lube" something, probably, i think Aciera mentioned it on another thread.

I'm back on 2.9 but Tommy is correct a lube pin. Easy enough to test just run Axis in 2.10.

JT

Yes, I found the commit in git