home button

Attach your hal and ini file and how did you create the configuration?

JT

For jogging after homing you would connect your pendant like this (example for x axis):

net jog-x-pos <= your_pendant_jog_x_plus_signal => halui.axis.x.plus
net jog-x-neg <= your_pendant_jog_x_minux_signal => halui.axis.x.minus

I try your solution but it doesn't work.

not much to go on I'm afraid. For assistance please share your current config and describe what is not working.

Have you checked that the pin ' hm2_7i76e.0.7i73.0.1.input-08' goes true when you press the button? (eg using 'halshow')
I presume you can jog the x-axis using the buttons on the GUI.

Note that this is only going to work AFTER homing the machine.

but my code true and blinking

Not quite sure what you mean.  So ' hm2_7i76e.0.7i73.0.1.input-08' goes true when you press your button connected to the 7i73 and you can jog using the buttons in the GUI?

Just to be clear, you want to check that ' hm2_7i76e.0.7i73.0.1.input-08' goes true in LinuxCNC using the 'Show HAL configuration' or 'Hal meter' tools.

So can you jog the x-axis using the button in the GUI (ie AXIS, GMOCCPY, QTDragon or whatever you are using)?

You should be able to see the pin 'hm2_7i76e.0.7i73.0.1.input-08' go true whenever you press the button that is connected to the mesa 7i73. If you do not see that change then there is a problem with the wiring of the button.

Also please attach your current hal and ini files so I'm not poking around in the dark.