mesaflash does not detect 7i92TF

There are no PWMgens in standard 7I76 firmware
(the Spindle Analog is done via sserial I/O)

It is not for a spindle, it would be for a laser. As I did not use the 5 axis, I believed that the 5 axis could be used as PWM, with the 5i25 it seems that an axis like PWM could be used.

I did not use the PWM (the 5i25 card was broken) but in Halsow 4 axes of steps and a PWM were seen.

The idea is to be able to remove the spindle and put the laser on the same machine, would create a different machine in Linuxcnc.

You would need to use firmware that has a PWMgen for that application.
I don't think there is currently firmware for the 7I92T +7I76 that matches the
5I25 firmware with one PWMgen  on the last stepgen, but I can build it.

I can have this done sometime later today or tomorrow.



 

7I92T firmware for one 7I76 with the last stepgen replaced with a PWMGen:

 

 

Thank you very much, it was not necessary so fast, this is a hobby.
I wish you a Merry Christmas.

Actually maybe a bit too fast... I think the last file has an error, so use this one instead: