tool for monitoring mesa inputs

Of course this can be done via linuxcnc - but is there a way to read inputs (or set outputs) on a mesa outside of linuxcnc?
Let's say I want to write some software that polls some inputs state?
 

Well, you could use mesaflash:

mesaflash --device 7i96s --addr 10.10.10.10 --rpo 0x1008

(reads the P1 expansion port GPIO on a 7I96)

mesaflash --device 7i96s --addr 10.10.10.10 --wpo 0x1108=0x1FFFF

Set all P1 GPIO as outputs

mesaflash --device 7i96s --addr 10.10.10.10 --wpo 0x1008=0xAAAA

Set P1 outputs to 0xAAAA

...



 

Oh! I wasn't aware this is possible with mesaflash.
Looks like that could be enough. Nice!
Thanks!