7i96s outputs closed when not activated, but loaded

Im getting to hooking up my cut60 plasma cutter to the board. using output 00  + and -, the torch fires as soon as i plug the connector to the board. I checked the board side and have OL resistance between the 2 ports when closed and very little when commanded open. i even tried wiring in a relay to control the torch and the 5v relay turns on the same way.
Anyone have any insight on what this could be?

Remove this line:

setp hm2_7i96s.0.ssr.00.invert-00 true

Also you should never hot plug inductive loads

Thanks! Ill give it a shot when in out at the shop.   

Noted

I had the polarity of the leads backwards. This was the initial issue, the invert would have been my next. Thanks for the help!