solved: TB6 Inputs missing in MESA 7i95T

Hi,I have refurbished an older ISEL Gantry CNC with a MESA 7i95T. (Only because 7i76ed was Out of stock..)All is working fine, exept one little detail:I can not find any of the Inputs in the hal, that are connected to TB6.
I have flashed the 1_pktv2 Firmware, to use RS485/Modbus with my frequency converter for the spindle. When I check the board with halrun, everything works fine. Exept, that I do not have any Inputs at TB6 listed.
The LEDs light up. So physically everything should be fine.

photos.app.goo.gl/H1fraX8DV1ccoN6j9
photos.app.goo.gl/62hDPX6Bzrdr1kGS7

Any Idea where I would find them? Is there anything else that needs to be configured?

Thanks a lot!

Cheers
Jan

The 7I95 isolated inputs are "inmux" pins

When LinuxCNC is running:

halcmd show pin *inmux*




 

Thank you.

Also I don't think pncconf supports the 7I95/7I95T but MesaCT does.