7i95t pin and firmware files with Stepgens and Inputs 5Axis BoB

 
Hi,

Please can anyone share 7i95t pin and firmware files with Stepgens on 1,2,3,4,5,6,7,8,9,14,16,17 and Inputs on pin 10, 11,12,13,15 pins on 5Axis BOB.


 

7I95T firmware for 5ABOB but with added stepgen on pins 1,14
(so 12 total)

 
 

Hi,
Thanks for your file. Please confirm if it contains the input pins information for 5 Axis BOB.
If not, please add the same.

Its is exactly the 5ABOB config for the Sainsmart 5 Axis BOB with an added stepgen
on DB25 pins 1 and 14 (removing the PWMgen from pin 1) all other pins are GPIO

Hi PWC will any 5-axis bob work with this firmware? The Sainsmart boards are hard to get in the UK

Most will work for step/dir but the spindle PWM output may be on different pins
What is the pinout of a breakout available to you?
 

I have just purchased a amazon bob. It looks similar to the one you mentioned. As far as I understand most of them have the same pins on the db25 port.

Hi,

a. Does these have inputs in the firmware for the 5ABoB on p10, p11, p12, p13, p15?

b. Also please guide as how I can update this new firmware on the 7i95t using Mesa CT.
Your help will be truly be appreciated.

A: All I/O pins are inputs unless selected for other use in the driver
(man hostmot2) or the hal file.

B: To program the firmware using mesaflash you would
download the firmware and then:

mesaflash --device 7i95t --addr [card_ip_address] --write 7i95t_5abobd.bin --reload

I would ask in the MesaCT section how to do this using MesaCT.

Thanks