Hi all,I'm struggling with the following Mesa card combination:
7i92 + 7i77 + 7i76.I’m using the firmware
Code:
7i92_7i77_7i76D.bit
. Unfortunately, only the Smart Serial peripheral on
P1 is being detected —
nothing shows up on P2.To clarify:
When I flash a different firmware, the same card that previously didn’t communicate on
P2 works fine on
P1, so I believe the Smart Serial slave and its power supply are OK.Here’s the output of
:
yaml
CopyEdit
Code:
mesaflash --device 7i92T --addr 192.168.1.121 --readhmid Module: SSerial There are 1 of SSerial in configuration Version: 0 Registers: 6 BaseAddress: 5B00 ClockFrequency: 100.000 MHz Register Stride: 256 bytes Instance Stride: 64 bytes
I read somewhere that there should be more than one SSerial interface listed if both ports (P1 and P2) are configured for Smart Serial. It seems like the firmware might not be enabling SSerial on both channels.Has anyone encountered this issue?
Or is there someone with a working build environment who could check the Mesa source files to see if there's a configuration error?Any help would be greatly appreciated.@PCW – if you have a moment, your insight would be very welcome.
