Linuxcnc 2.9.7 - Mesa 5i25 with HKD 5 AXIS MACH3 STEPPER I/FACE and 5i25_5ABOBx2

Hello,
I've spent a few days getting Linuxcnc 2.9.7 up and running with a Mesa 5i25 board, properly flashed and functioning.
My hardware setup consists of 2no X-axis gecko 203V drives, 1no Y - axis, 1no Z-axis, and 1no A-axis.
I have x,y,z home switches, e-stop, and Highspeed Spindle.

I have been trying to get the mesa card to work with a HKD 5 AXIS MACH3 BOB.
Currently i can get mesa to drive the gecko drives and motors if I connect directly (Testing Purposes Only).
I cannot get the HKD BOB to drive the gecko drives and motors.

Does anyone have suggestions?

Thanks,
Orrin
 

Do you have a link to the manual for the HKD breakout?

Also make sure you do not have cable power enabled on the 5I25.

Here is the files that were posted for it.

 

The link. www.communica.co.za/products/hkd-5-axis-...riant=31916110839881  

Breakout power option is off.

Did you verify that  the BOB has 5V power?
It needs both 5 and 12V power for operation,
5V for the step/dir outputs and 12V for the analog out and digital inputs

Bob has 5v using usb.
I'm only working with 5v now to get step/dir outputs working.
I will connect the 12v supply to run the spindle.

I've ordered a MESA 7i76U, should get the machine up and running once configured.

I'm going to park this one.