I have my 7i96 working with a CommanderSK VFD over RS485 with hm2_modbus. (See attached)I write two registers using the init section but I haven't figured out the syntax to read registers in this section. Could anyone provide an example of reading registers during init? I'd like to only read the rated rpm, amps, etc once and I need the values in hal.I would also appreciate an example showing how to set the HAL_FLOAT scale factors. (in the .mbccs) I am currently using
Code:
setp hm2_modbus.0.vfd.ref-coarse-00.scale 10.0
It seems like this belongs within the .mbccs definition.
