Brother TC-225 / TC-229 adventure!

These are ac servos. noise should not be of any issue as it a differential analogue signal.

I think its just connected wrong.

alexbrem89 wrote:

Does anyone happen to know how I can connect the spindle orientation?
I have the spindle turning, but not yet the orientation
 

I never got that far with mine. I dont think its covered in this thread, but i think some others did it elsewhere. I think most people switch the spindle to A axis, and then home. 

wiring for the sanyo drives. i forget now if the toshiba are different.  you really do need it all connected including voltage references, start(enable), etc.
 

its fixed now, it was some small potentiometer on the drive that was set to set wrong position and after that it runs super smooth

woo