biesse rover 316 retrofit

nesto na ovu foru imam ako imas nacin da prevezes poklanjam

  New wiring today.. does anyone used 7i66 , i connected trough 7i74 and 7i74 on 7i92.. but pnccnfig doesn’t see 7i66, is this wiring correct or to connect 7i66 directly on 7i77 sserial?

PncConf will not help with 7i66, start LinuxCNC and use "show hal configuration" to find the pins.
And do check the red wire on the orange connector on the 7i77, it looks like it is falling out of place.

ok i connect now on sserial on 7i77 as you suggested before direct.. now we will see..( red wire is ok i just bend wire and look like on photo as it’s not connected)..Hvala:)

  Now see her in hal config!-) if I can't see it in pncconf ... how can I put these outputs to work via MDI 62-65 or M6 (unclear to me) so i would like that these outputs activate the drill solenoids?

LinuxCNC = Ducati "Virus"
PncConf = bike with training wheels

Make a config that does basic stuff, save a copy, start editing the hal and ini files.
Now you have the pin names so adding them to the hal file and wiring them to solenoids and other stuff is a simple as:
net somesolenoid hm2_7i92.0.7i66.0.2.output-00
or
net machine-is-enabled hm2_7i92.0.7i66.0.2.output-04

``LinuxCNC = Ducati "Virus"
PncConf = bike with training wheels``

thank you Tom but i have to learn and learn...
ok it is clear to me to just write that lines to hall(maybe)..maybe stupid question ..but i want to activate for example solenoid(1) by mdi (example)M64 P01 and in gcode maybe..
How Linuxcnc know that i want P01(output) from 7i77 or P01(output) from 7i66 ,by MDI command?

do i need to write M1xx user defined M codes ?

or you mean to make hal file for m6 command toolchange?

linuxcnc.org/docs/html/gcode/m-code.html#mcode:m62-m65
and section 1.2 here
linuxcnc.org/docs/html/config/core-components.html#sec:motion
so in hal it is And in gcode
M64 P1 would turn on solenoid-dva
M64 P0 solenoid-jedan
etc.