Hurco ultimax ultimax 2 ultimac3 breakout board idea

do we have a pin out ?

I might be able to source one.

This is all i had to go on when i did that retrofit, notice that i added the wire coloring for motor cable and controller cable.

I've not forgotten about this, just been busy, looking for a controller board to copy or at least emulate

I have a machine i can pull the board from if you need them

smc.collins wrote:

I have a machine i can pull the board from if you need them

Thanks, not nesssary (yet).  Just trying to get my head into the control panel.

This seems to have been a very detailed post:
forum.linuxcnc.org/42-deutsch/33942-stra...rives-to-mesa#105312

I have a SLV 40 with ultimax 3 controls, and I need to get a machine retrofitted soon, I am very limited by the ultimax controls. Not a fire just yet, but as soon as my lathe is running, I need to converter one of my 3 mills , and then the other 2.