Partizipation Manual Deutsch Übersetzen - git.linuxcnc.org (off?)

O.K., and I think the 90users-file was correctly create, in the right folder and the tow lines per copy&paste.

Now I try the fourth step again - creating document.

agk@debian:~$ cd linuxcnc-dev/src
agk@debian:~/linuxcnc-dev/src$ ./autogensh
bash: ./autogensh: Datei oder Verzeichnis nicht gefunden (file or folder not fund)
agk@debian:~/linuxcnc-dev/src$

Thats meaning I need new syntax?

Now I see it, the point is missing

./autogen.sh

not

./autogensh

It's running. The output:

I have not delete the 90userprefs - I do this and try again

If 90userprefs deleted ./autogen.sh is not running > bash autogen.sh: Kommando nicht gefunden (command not found)

Is that why the 90userprefs was not deleted at the right time?

AGK wrote: It's running. The output:

It looks like the German doc was built, did you do the translations ?

Before I explored the "How-To-Translating" her, I have translate some pages. To test that I finished the folder "motion"with the three chapters. That because: "You must be very careful not to change formatting of links, anchors and titles or it will not build." Now I can see some PDF-files but not the translated chapter "kinematics", pid theory" and tweaking steppers" What is wrong? My text is without simple break on end of line, is this a problem?

My txt-file looks like:

The next point: I have controlled all the txt-files in linuxcnc-dec, and had compare it with the LinuxCNC_Documentation.pdf. A lot of content are missing. Ozzyrob you are member the group of developper for documentation? Or shoud I take contact per E-Mail (emc-users@lists.sourceforge.net).? .