tutorial for pncconf and Mesa 5i25/6i25/7i92 to basic configuration section.

forum.linuxcnc.org/49-basic-configuratio...rallel-port-bob-g540

Well done Tom. You need to edit the title though.

phillc54 wrote: Well done Tom. You need to edit the title though.

Oh please do tell...

tommylight wrote:

phillc54 wrote: Well done Tom. You need to edit the title though.

Oh please do tell...

stepconf V pncconf !!

Clive S wrote:

tommylight wrote:

phillc54 wrote: Well done Tom. You need to edit the title though.

Oh please do tell...

stepconf V pncconf !!

Nice idea, thank you Clive.
Phill is holding back on me, no beers for him !

tommylight wrote: Phill is holding back on me

Sorry Tom, I got a bit distracted.

, no beers for him !

Bugger, looks like a Jameson instead. :blink:

Took me a while to figure out, with the help of Chris as it was staring at me and i could not see it !
From 8AM to 3AM working in the shop on those 2 machines, to much math, drilling, chamfering, tapping, screwing (not around ), hal editing, tuning, reading and replying, smoking, coffee, wiring, etc etc. And then i could not sleep till 5AM, brain was still at full speed churning!
Now if i knew what Jameson was .....

Yes, I see now that I was a bit vague...
That would be an Irish whiskey.