HAL Oscilloscope application has no Chan Off button...

Hi,

I am not sure if this post is in the place or not. Please excuse me if it is not.

I am doing HAL basic tutorial: linuxcnc.org/docs/html/hal/tutorial.html#cha:hal-tutorial , under section 6.6. More Channels, Figure 13. Step Pulses shows HAL Oscilloscope with the Chan Off button, my version of the HAL Oscilloscope does not have one:



My LinuxCNC version is 2.9.3, which I built from source on November 6, 2024.

What can I do to fix this one, please?

Thank you.

The documentation is outdated, try clicking on the colored channel buttons on the bottom of the screen to toggle channels on/off. Eg the red button with '1' on it.

Aciera wrote:

The documentation is outdated, try clicking on the colored channel buttons on the bottom of the screen to toggle channels on/off. Eg the red button with '1' on it.

Hi Aciera, thank you. I have just now re-run it. It works as you have indicated. Best regards.

Aciera wrote:

The documentation is outdated, try clicking on the colored channel buttons on the bottom of the screen to toggle channels on/off. Eg the red button with '1' on it.

Fixed in github.com/LinuxCNC/linuxcnc/commit/e412...449b7450922240e9b9c1