a chinese translation for EMC2 manual

  • dinglei618@hotmail.com
  • Topic Author
  • New Member
  • New Member
More
15 years 1 week ago #13988 by dinglei618@hotmail.com
a chinese translation for EMC2 manual was created by dinglei618@hotmail.com
Hi guys , i have translated " EMC2_Getting_Started " into chinese .

Now i am translating "EMC2_User_Manual ".

Please visit my blog : blog.sina.com.cn/u/2370524133

Your visit will give me encouragement , thank you .

Please Log in to join the conversation.

More
15 years 1 week ago #13990 by kostas
Nice! I visited you blog already.

Greetings from Greece!
Kostas

Please Log in to join the conversation.

More
15 years 1 week ago #14015 by andypugh
It should be possible to get the translation hosted with the other document translations.
You might also want to check the localisation of the software:
wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Internationalization

Please Log in to join the conversation.

More
15 years 1 week ago #14033 by darty367
Good job B)

Please Log in to join the conversation.

  • dinglei618@hotmail.com
  • Topic Author
  • New Member
  • New Member
More
15 years 1 week ago #14042 by dinglei618@hotmail.com
Replied by dinglei618@hotmail.com on topic Re:a chinese translation for EMC2 manual
Andypugh , You are right . But i did not use wiki before.

I'll try anyway.

Please Log in to join the conversation.

More
11 years 4 months ago #59973 by Tylk
You did a good job. :laugh:

Please Log in to join the conversation.

More
7 years 3 months ago #140051 by Dinuka_Shehan
Good job
Keep it up
Greetings from Sri Lanka.
Dinuka Shehan

Please Log in to join the conversation.

Time to create page: 0.178 seconds
Powered by Kunena Forum