Upgrading and migrating the LinuxCNC Forum

  • cradek
  • New Member
  • New Member
More
10 years 11 months ago #65169 by cradek
Replied by cradek on topic Upgrading and migrating the LinuxCNC Forum
In Windows XP you will have to use the http: url, not the https:, because Windows XP's https support is too old.

Please Log in to join the conversation.

More
10 years 11 months ago #65217 by Todd Zuercher
Replied by Todd Zuercher on topic Upgrading and migrating the LinuxCNC Forum
It would be nice if there was a link back to the main Linuxcnc.org site at the top of the page.

Please Log in to join the conversation.

More
10 years 11 months ago #65218 by LearningLinuxCNC
Replied by LearningLinuxCNC on topic Upgrading and migrating the LinuxCNC Forum
There is. it is the Home link at the top of the page.

Please Log in to join the conversation.

More
10 years 11 months ago #65220 by Razor_keen
Replied by Razor_keen on topic Upgrading and migrating the LinuxCNC Forum
I seem to not be able to reply in my own topic. Is there a good reason for this?

Please Log in to join the conversation.

More
10 years 11 months ago #65223 by Rick G
Replied by Rick G on topic Upgrading and migrating the LinuxCNC Forum
Just tried in off subject/ test post.
Worked for me.

Rick G

Please Log in to join the conversation.

More
10 years 11 months ago #65224 by Razor_keen
Replied by Razor_keen on topic Upgrading and migrating the LinuxCNC Forum
the title of my topic was ubuntu 14.04.1 linuxcnc help. try that one

Please Log in to join the conversation.

  • jepler
  • Topic Author
  • New Member
  • New Member
More
10 years 11 months ago #65242 by jepler
Replied by jepler on topic Upgrading and migrating the LinuxCNC Forum
Some categories were marked read-only after the upgrade. I've tried to correct them all. If you spot another one that doesn't allow replies or new posts, just reply here and let us know.

Please Log in to join the conversation.

More
10 years 11 months ago #65280 by gaston48
Replied by gaston48 on topic Upgrading and migrating the LinuxCNC Forum

It would be nice if there was a link back to the main Linuxcnc.org site at the top of the page.


Yes! :) with http instead of https

Please Log in to join the conversation.

Time to create page: 0.066 seconds
Powered by Kunena Forum