Could not insert module error

Well I thought I was getting closer.

I am getting this now on startup

It all started as I was trying to change some inputs on a few things in the ppmc_io.hal

so I killed that configuration and loaded a new configuration, but am still getting the same error.

Any tips on what I screwed up this time? I am not sure where to go from here as I can not even get it to load with a fresh configuration.

Try a reboot, in case the module was not properly unloaded previously

Any tips on what I screwed up this time? I am not sure where to go from here as I can not even get it to load with a fresh configuration.

Please attach your hal and ini file, only you currently know what is in them.

See the output of 'dmesg' for more information.

After getting this error, do dmesg > dmesg.txt in a terminal and attach that dmesg.txt file too

I will get that info and post it tonight. I finished getting the LAN cable out there last night, so now I can get the files up on GITHUB

Thanks!

Here are the files,

Thanks!!

Even with a fresh config after a full shutdown, same error. I made it very mad.

im going to take the rest of this back to my orginal machine thread instead of muddying up the forum

It is failing to find the PPMC board.

Is the parport address right? Is EPP enabled?

Andy beat me to it

Not in EPP mode looks favorite

[ 113.829923] PPMC: checking EPP bus 0 at port 0378

Since I dumped the entire config when I got pissed I lost the address setup. The next morning when I woke up I it dawned on me that I never did that. I was pretty pissed at myself as I spent that much time over that.