USPACE

Hi,

I'm trying to load a new component, and realized (I might be wrong... but it appears:) that on Weezy, RT version I cannot run linuxcnc-dev. I restarted my pc on RTAI, and could then use linuxcnc-dev to install a component. But now when I try to start linuxcnc (the config with the new component) - Debug file information : Note: Using POSIX non-realtime 4185, PID TTY STAT COMMAND, 4212, PID TTY STAT TIME COMMAND, Stopping realtime threads, Unloading hal components
Note: Using POSIX non-realtime.

? Any Idea what this means?

I loaded the component on Ubuntu, and it works perfectly. I need to make a decision on what to do, I am possibly going to have to take this pc back to Ubuntu? I hope not. I like to move forward...

Can you give a little more detail about the steps involved?

When you "say linuxcnc-dev" do you mean the package that allows you to compile components, or the development version of LinuxCNC.

Yes, more detail. I have one computer running LinuxCNC Uspace and can test...

JT

Hi John and Andy,

Thanks for your attention on this matter. linuxcnc-dev, the component that allows you to create/install new components. How ever, I managed to install it on my laptop for the simulation, and had success. so I'm back at work this morning, and going to try it again, It is possible that I missed something. I will give feedback as soon as I managed to locate my problem.

Once again thank you for your attention to this, I appreciate your input.

Hi Andy and John,

My bad... Not 100% sure what I did wrong previously, but followed the steps this morning, and all working well... Happy days.

Thanks for your willingness to help anyway, and sorry...

oh... I shouldn't forgrt to mention that my command in Ubuntu was

sudo halcompile --install XYZBCkins.c

but in Wheezy it was :

sudo comp --install XYZBCkins.c

(To find out these differences I had some help. Without Prof. Rudy's help, I would not have figured this out.)