Raspberry Pi 3

More
10 years 7 months ago #72467 by markehle@gmail.com
Raspberry Pi 3 was created by markehle@gmail.com
Folks - now that the Raspberry 3 is out, does that change anything with respect to installing Linuxcnc? Seems to me that the new unit finally has enough power to run LinuxCNC well.

Please Log in to join the conversation.

More
10 years 7 months ago #72471 by andypugh
Replied by andypugh on topic Raspberry Pi 3
Do you have any idea what the latency would be like?

Were you thinking of using the GPIO pins or something else? SPI might be an option. Etthernet isn't, with the Pi, as it is on the USB bus.

www.frank-durr.de/?p=203

Please Log in to join the conversation.

Time to create page: 1.712 seconds
Powered by Kunena Forum