Show axes letters instead numbers

More
10 years 4 months ago #75389 by isladelobos
Show axes letters instead numbers was created by isladelobos
How?

In the .ini file?
Code:
TRAJ] #+ machine specific settings AXES = 9 COORDINATES = X Y Z B C W HOME = 0 0 0 0 0 0
Code:
#- Introductory graphic INTRO_GRAPHIC = emc2.gif INTRO_TIME = 5 EDITOR = gedit INCREMENTS = 5mm 1mm .5mm .1mm .05mm .01mm .005mm GEOMETRY = XYZBCUVW #LAST_POSITION = last_position.txt

Or hal file.

This is one XYZBCW steppers machine.
I use for display tkem

Please Log in to join the conversation.

More
10 years 4 months ago #75397 by andypugh
Replied by andypugh on topic Show axes letters instead numbers
Which kinematics file are you using? Which version of LinuxCNC?

Please Log in to join the conversation.

More
10 years 4 months ago #75411 by isladelobos
Replied by isladelobos on topic Show axes letters instead numbers
Hi.

Im using 5axiskins with 2.6.8

Please Log in to join the conversation.

More
10 years 4 months ago #75414 by andypugh
Replied by andypugh on topic Show axes letters instead numbers
[strike]I don't know how to switch from Joint Mode to World Mode in tklinuxcnc.
In the Axis interface you use the $ keyboard shortcut.
tklinuxcnc is currently deprecated, and is probably a poor choice for a non-trivial kinematics machine.[/strike]

This was mainly incorrect info.

Please Log in to join the conversation.

More
10 years 4 months ago #75420 by andypugh
Replied by andypugh on topic Show axes letters instead numbers
Use the "World Mode" checkbox to display XYZ rather than 012.

Please Log in to join the conversation.

More
10 years 4 months ago #75422 by isladelobos
Replied by isladelobos on topic Show axes letters instead numbers
Stuff !!! thas was simple!!! :ohmy:

Thanks and sorry for the delay.

Please Log in to join the conversation.

Time to create page: 0.087 seconds
Powered by Kunena Forum