g code out of range

That would only change how CRLF are output and that should only be end of line not after G

clayton cramer wrote: That would only change how CRLF are output and that should only be end of line not after G

I agree, but I am running out of other ideas.

It is quite clear what causes that error. It is hard to see what might trigger that error in your G-code as-published.

Be aware that the system is not very good at pin-pointing the _exact_ line that has the error. The problem is often a few lines above or below the number given.

I am also confused by your statement that the line where the error is raised is because there isn't a line like that in yout G-code.

Also if you wish to have the gcode checked, you should post the entire file with a file upload or provide
a link to the file (instead of pasting it into the message text) since if there are any hidden control characters, they
will be stripped from a paste into the page