Ethernet PokeysCNC LinuxCNC

Hi DaBit,
Thank you very much for sharing your code, given that it connects via USB serial no? I have POKEY57E in ethernet mode works with TCP IP ??
thanks for everything
Chimeno

I am using Ethernet also. So far I had exactly zero issues with the Pokeys57E which cannot be said from the 57U. USB and CNC machines are a bad match.

But it works seamless with both Ethernet and USB. The PK_ConnectToDeviceWSerial function in the code uses the PoKeys serial number to find the right device, and the data transport is abstracted away by the PoKeys library.

hi DaBit,
I'm going to try it and have if I can make it work and I'll tell you how everything goes, thank you
Chimeno

hi DaBit
I have a problem that I could not solve myself, if you can help me, I think everything is installed, when I start linuxcnc I have the following error "pokeys: dlopen: /usr/lib/linuxcnc/modules/pokeys.so: can not open shared object file: no such file or directory ", I need to suppose that file, where can I find it? or what should I do? =, thanks Chimeno

Did you install the Pokeys library using the 'make -f Makefile.noqmake install' command?
( bitbucket.org/mbosnak/pokeyslib )

If yes, try 'sudo ldconfig'

hi DaBit,
if the library is installed.
The command "sudo ldconfig" has not made any effect, I have the same error, where is it or where can I get it "pokeys.so", it is not in the / usr / lib / linuxcnc / modules directory, you have some more idea than I can try?

resolved
I had a problem that loaded the mudulo in "loadrt" instead of "loadusr", now to see if I can communicate.

thanks Chimeno

Hi guys,
I am trying to use Pokey57E with the PoNET Bus through the library "PokeysLib.h" to create a driver and to use the Kbd48cnc keyboard, I attach the file that passed me Matevž de polabs of the transmission protocol, not if someone is interested and can help me in the process, thanks to everyone, every day linuxcnc is bigger!
Chimeno

Hello everyone,
at the moment I have the keyboard worked through modbus and classicladder, it is the second time I integrate it and the truth is quite good, when I have a little more time I would like to create a specific component
regards
Chimeno

Hello,

were you able to convert the Pokeys57U to run on Linuxcnc? I am currently running my 5axismaker machine on mach4 as instructed by the vendor but I want to switch to linuxcnc. Let me know, thanks!