It couldn't be caused by noise? Like this thread:
forum.linuxcnc.org/10-advanced-configura...h-touch-off?start=30
HAL Meter shows false and true (when pressed).
That's a bit strange though.
Edit
Found it!!! finally
Can't explain exactly why.
This is the working config in my .hal file
# ---probe signal---
net probe-in => motion.probe-input
net probe-in <= hm2_5i25.0.7i76.0.0.input-11-not
It should be done like this if I check the documentation.
But it didn't work: net probe-in => hm2_5i25.0.7i76.0.0.input-11-not
