Axis default ngc file

How does one setup axis to startup with the last ngc file used?

As said on the IRC that's not an option.

However you could write a python filter program to change your ini file each time a new ngc file is loaded... might work. The other option is to change Axis itself.

JT

You can make it start any file, just add a line in the ini file, but it will open always that same file.

ArcEye did a hack for Axis a while back that reads the last file from the .axis_preferences file and loads it.

JT

Yes, I found, implemented it. It works. What is the format of the statement that would go in the General section of the ini file to open with say "test.ngc"?

jensor wrote: Yes, I found, implemented it. It works. What is the format of the statement that would go in the General section of the ini file to open with say "test.ngc"?

[DISPLAY]
OPEN_FILE = /full/path/to/filename.ngc