Parameter list

AThayer
Topic Author
Offline
Junior Member

9 years 8 months ago #88091 by AThayer

Parameter list was created by AThayer

I looking for a parameter list for linuxcnc. I'm drilling using a G83 and I would like to control the back off amount.

Please Log in to join the conversation.

Todd Zuercher
Offline
Platinum Member

9 years 8 months ago #88097 by Todd Zuercher

Replied by Todd Zuercher on topic Parameter list

The R word used with G83 sets the retract height. If you want a different retract between pecks and the move between holes, I think you can add G98 to the mix.

Please Log in to join the conversation.

Time to create page: 0.081 seconds