Install PID module for LinuxCNC

More
8 years 11 months ago #101892 by Todd Zuercher
Replied by Todd Zuercher on topic Install PID module for LinuxCNC
Usually pid.N.enable is connected to the enable signal for the axis/joint it is used with (axis.N.amp-enable-out).

Please Log in to join the conversation.

More
8 years 11 months ago #101894 by Bello
Replied by Bello on topic Install PID module for LinuxCNC
Ok, got it, this is the reason why my axis was not able to move.
Thank you!

Please Log in to join the conversation.

Time to create page: 0.031 seconds
Powered by Kunena Forum