Hello,
Using linuxcnc 2.8.0 pre1 in lathe mode, on a real machine I found the following issues. There is a possibility that some are not bugs, I am posting at the best of my knowledge:
1) Jogging with the jog keys (keyboard) all move the Z axis (up and down included that was supposed to move the X). The "direction keys" on the numerical keyboard are ok
2) When a program is finished and the last spindle mode was G96 (constant surface speed), when loading any other program (including the exacly same program that was just completed), the error "S word missing with G96" shows up, even if the program is ok. My turn arround solution was to issue in MDI "G97", then I can load any gcode file again.
3) I am using the "inverted front view" present in the top bar of axis, as I have a back tool post. When loading a new program this view goes away and I need to select again that view.
For now I think that this is all, if I should post elsewhere, please inform.
Thank you
