Optical encoders with DC motors

Hi Mike, I don't understand what you mean?
How can you connect Enable, step, dir of all drivers together?

Nop..naturaly not in that way!

Connect all 3 driver-enable signals together.

Plus 3 times the two signals for each motor.
Naturally each motor needs his own step and his own dir.

In sum you control the three motors with 7 output signals..

Mike

In bios the port remains EPP, you do not need to change that. To change the mode you just have to add that to the HAL file at the part where it loads the parallel port driver, something like:
loadrt paraport "0x387 out" for normal operation, 8+4 out/5 in
loadrt paraport "0x387 in" for 13 in and 4 out
loadrt paraport "0x387 x" for 9in and 8 out

You have to double check that as it has been quite some time since i messed with that.
You can also add another pci or pci-ex card with parallel port so you can double the in/out pins as you like.
Then again, a Mesa 5i25 or 6i25 has two such ports and can operate at a much higher speed for a bit more money, worth every dime. I have nearly 4000$ of mesa boards installed on several machines, one 5i25 is still sitting in the box but not for long and a complete set consisting of 6i25, 7i77, 7i74, 2x 7i84 and a THCAD on a piece of wood with a PC wired and used for testing and making PyVCP panels as needed for machines i retrofit.

With the motherboards I have tried X-mode will not work with the parallel port set to EPP.

Hmmmm sorry for that EPP misshap, i set parallel port to ECP and 1.4 version whenever possible.
I also have several PCI cards that can do X mode with NetMos chips on them, manufactured cicra 2008-2012.
Again, sorry.

Guys, here is the result of my work over optical encoders and PID control in LinuxCNC the last days:

Just a small correction, it should say :
Simplest SERVO controlled CNC machine ever !
Glad you got it working, just goes to show how versatile Linuxcnc is.
Just in case you missed it, there is another thread for using 4 darlington transistors and 4 resistors for controlling a stepper motor, a total of 2$ in parts.
Regards,
Tom.

Hmm, I've got a couple of small Yaskawa servos with their drivers here. So could these be driven from a parallel port too?

What do you guys think?

What model where they?

tommylight wrote: What model where they?

That Tommy is a very good question! But I can't answer it until I find them!