The error I received is : custom_postgui.hal:62: Pin 'halui.jog-speed' does not exist
Note that for the master branch (2.8~pre), some pins are renamed to conform
to joints/axes updates.
Many updates for the master branch are documented:
linuxcnc.org/docs/master/html/getting-st...dating-linuxcnc.html
These documents note halui pin renames and new pins:
Code:
was: halui.jog-speed is: halui.joint.jog-speed
And:
Code:
New pins for teleop jogging are:
new: halui.axis.jog-speed
new: halui.axis.jog-deadband
new: halui.axis.L.plus
new: halui.axis.L.minus
... etc.
Ref:
linuxcnc.org/docs/master/html/getting-st...linuxcnc.html#_halui
Regardless of branch in use, the halui man page lists available pins:
Note: Wiki entries are often unreliable as no one takes responsibility
to update or note differences occuring for the LinuxCNC development
branch (master == 2.8~pre)
