2.8 pre - external offsets and negative adaptive speed working, check this !!

More
8 years 5 months ago #110701 by Grotius
2.8 pre - external offsets and negative adaptive speed working, check this !! was created by Grotius


reprository : github.com/michelwijnja/external_offsets.git

to install :

git clone github.com/michelwijnja/external_offsets.git linuxcnc_external_adaptive
cd debian => configure -r
cd src => ./autogen.sh + ./configure
make -j2 + sudo make setuid
cd scripts => . ./rip-environment + linuxcnc

To enable adaptive-feed, type in mdi : m52 P1
To play with negative adaptive feed, type in halshow command line : setp motion.adaptive-feed -1

Please Log in to join the conversation.

More
8 years 5 months ago #111369 by grijalvap
Replied by grijalvap on topic 2.8 pre - external offsets and negative adaptive speed working, check this !!
what is adaptive sped?

Please Log in to join the conversation.

More
8 years 5 months ago #111370 by cmorley
Replied by cmorley on topic 2.8 pre - external offsets and negative adaptive speed working, check this !!
_negative_ adaptive speed allows the gcode program to run backwards with some limitations.

Chris M

Please Log in to join the conversation.

Time to create page: 0.078 seconds
Powered by Kunena Forum