Thread milling.

marsheng
Topic Author
Offline
New Member

8 years 4 months ago #111487 by marsheng

Thread milling. was created by marsheng

If I want to thread mill, does the spindle shaft need to run an encoder or will a single prox on the shaft be enough to synchronize the z with the x and y travels ?

My spindle max is 6000 RPM.

Running Mesa boards (when I get it running !!!)

Please Log in to join the conversation.

BigJohnT
Offline
Administrator

8 years 4 months ago #111505 by BigJohnT

Replied by BigJohnT on topic Thread milling.

Thread milling is just G code, no spindle sync is needed. For rigid tapping you need an encoder on the spindle.

JT

Please Log in to join the conversation.

Time to create page: 0.091 seconds