Not run Calibrate axis in LinuxCNC

More
8 years 2 months ago #116405 by Nikomas
Not run Calibrate axis in LinuxCNC was created by Nikomas
Hi, Sorry for my english. Look at my problem:
When I open EMC with my confogs and click "Calibrate axis" in linuxcnc - nothing happens.
If I create config from examples (AXIS) - "Calibrate axis" starting and working.

Whats wrong?

Attachment not found

Attachment not found

Please Log in to join the conversation.

More
8 years 2 months ago #116407 by BigJohnT
Replied by BigJohnT on topic Not run Calibrate axis in LinuxCNC
What branch of LinuxCNC are you using? Nothing Happens == the popup window does not appear? What GUI are you using?

In Axis if there are no tunable parameters the screen still shows up.

JT

Please Log in to join the conversation.

More
8 years 2 months ago #116408 by Nikomas
Replied by Nikomas on topic Not run Calibrate axis in LinuxCNC

What branch of LinuxCNC are you using?

2.7.0

Nothing Happens == the popup window does not appear?

yes

What GUI are you using?

Axis

In Axis if there are no tunable parameters the screen still shows up.

Sorry but I dont understand what u mean.

Please Log in to join the conversation.

More
8 years 2 months ago #116413 by BigJohnT
Replied by BigJohnT on topic Not run Calibrate axis in LinuxCNC
In Axis when you press the Calibrate menu item a popup window comes up even if nothing is found, do you get this?

Attachment not found



JT

Please Log in to join the conversation.

More
8 years 2 months ago #116418 by Nikomas
Replied by Nikomas on topic Not run Calibrate axis in LinuxCNC
No.I can see this popup.

Please Log in to join the conversation.

More
8 years 2 months ago #116419 by BigJohnT
Replied by BigJohnT on topic Not run Calibrate axis in LinuxCNC
What is not working?

JT

Please Log in to join the conversation.

More
8 years 2 months ago #116421 by Nikomas
Replied by Nikomas on topic Not run Calibrate axis in LinuxCNC
Sorry. I cann't see this popup.

Please Log in to join the conversation.

More
8 years 2 months ago #116422 by BigJohnT
Replied by BigJohnT on topic Not run Calibrate axis in LinuxCNC
Run LinuxCNC from a terminal and see if any errors show up in the terminal.
Code:
linuxcnc

JT

Please Log in to join the conversation.

Time to create page: 0.134 seconds
Powered by Kunena Forum