siemens servo compatibility

Did you intentionally blur the photo, or what?

Those are "MASTERDRIVE MC", by the purple lines I can see that they are controller via ProfiBUS. They can also be configured to use analog or RS232 command source.

Servomotors have 1Vpp sin/cos signals, Heidenhain ERN1000 series encoders.

Why sud i intentionally blur the photo:dry: :dry:

so can i use them with linuxcnc?

Is this more helpful

You should be able to use them with LinuxCNC, if you can figure out how to configure them for analogue voltage control rather than Profibus.

You would also need to find out which pins/connectors need be connected for analogue voltage control.

I don't have the knowledge to do that
thanks for the info

That is what Google is for, use it to dig up a manual for your drives and read it.

siemens have a great user documentation area. You can find nearly all documentation for all motors, drivers software. The Problem is, all parts from the newer machines are digital controlled.
support.industry.siemens.com/cs/document...dti=0&dl=en&lc=es-CO