Detecting No Tool Loaded

pl7i92
Topic Author
Offline
Platinum Member

7 years 9 months ago #123980 by pl7i92

Detecting No Tool Loaded was created by pl7i92

Hi is there a Way to detect there is no tool loaded in G-code

My tool is 0 to get the length measurement
I CAN DO
O105 If[#5400 GT 0] ....

This gives tool Numbers
BUT NO Tool Loaded is the Thing im searching For

Please Log in to join the conversation.

pl7i92
Topic Author
Offline
Platinum Member

7 years 9 months ago #123986 by pl7i92

Replied by pl7i92 on topic Detecting No Tool Loaded

Thank You on The IRC Channel Helpd me

THIS is the Answer for Detecting

Code:

o<testp> sub
o155 if [#5410 LE 0]
  (msg,No Tool Loaded)
o155 endif
o156 if [#5410 GT 0]
  (debug,Tooldiameter: #5410)
o156 endif
o<testp> endsub
m2

Please Log in to join the conversation.

MaHa
Offline
Platinum Member

7 years 9 months ago #124010 by MaHa

Replied by MaHa on topic Detecting No Tool Loaded

I would choose Z #5403, for test. Why? Sometimes i use T1 with tooldiameter 0, to deburr a contour, made with cutter compensation, so i can use the same subroutine with z-0.5.
In that case the tool would not be detected.

Please Log in to join the conversation.

Time to create page: 0.077 seconds