how to define a 90 deg cone cutter in the tool table?

Well the subject say's it

I want to define a V-carve tool with a 90 deg end 1/2 dia.

Thanks
Jim

why woudt you define a cone cutter in the tool table

the Gcode is produced by a CAM system si it is to define there
only the Discribtion is to be enterd and the diameter

jamby wrote: I want to define a V-carve tool with a 90 deg end 1/2 dia.

Sorry, but you can't.
(And LinuxCNC wouldn't know what to do with the data if you could)

The graphical preview only shows the tool centre point path anyway, so you don't lose much.

Thanks Guys

When I set back and think about it, it doesn't make any difference.

Thanks again
Jim