external start

i need external start button in my program what files do i need to configure in order to do that

Halui is your friend. Check the docs but try halui.machine.on

I need more help than that i dont know anything about hal

OR JUST TELL ME WHICH FILES I NEED TO CONFIGURE AND ILL FIGURE IT OUT

in the INI of your mashine
enable in HAL section POSTGUIFILE
# Single file that is executed after the GUI has started. Only supported by
# AXIS at this time (only AXIS creates a HAL component of its own)
POSTGUI_HALFILE = mtest_postgui.hal

HALUI = halui


THEN in the postgui FILE
# External Mashine on
net ext-mashine-on halui.machine.on <= YOUR PIN

video to do it Axis button



infos here
linuxcnc.org/docs/html/man/man1/halui.1.html


IF you tell us here where and how did you connect your button
we can give you the clear and correct command to put in postgui file

sir i connected that button to parport.0.15.in
i.e. pin no 15 on my parellal port

thanks
then its
# External Mashine on
net ext-mashine-on halui.machine.on <= parport.0.pin-15-in

i added that line to my filename.hal axis starts without errror but button not doing anything
i have push button connected to pin 15

can you please post the ini and Halfile

i guess you dident do what we talked about
there is to be a new HAL file inside your mashine Folder

these are my files
thanks buddy your help is greatly appreciated

i need help qickly