Linuxcnc wont start own configuration

Hey folks!

I've got a Problem with my System.

Things starte like this: i tried to install Teamviewer, that didn't work.
After that I also couldn't connect to apt-get Servers.

So I took out my Debian 9.9 CD and refreshed the System from Zero.

I installed everything like the time before.
So Debian 9.9 Made it for preempt rt(ethernet mesa Cards)
And then installed Linuxcnc 2.7.14

But now! Linuxcnc wont open up again with my own config.
Examples work, but none of my own configs Do so.
Also there pops no error message Window up.

What could have happened?

Thanks guys!!

Wrong version of Linuxcnc ???
There are a lot of differences between 2.7 and 2.8 in joint/axis setup so that might be one reason.
You need to attach some logs and error mesages, otherwise it is just a guesing game.

Open a terminal and run your configuration and see if you get an error message there. After attempting to run in a terminal type dmesg to get system messages.

JT

Thanks guys!

Starting Linuxcnc in terminal showed me the mistake- the mesa's were not connected at that point- little mistake BIIIIG Fault .

Thanks for helping )