Not moving forward in gcode after m3

7 years 3 months ago #138497 by phoenix

Not moving forward in gcode after m3 was created by phoenix

Its just not moving past this line

Please Log in to join the conversation.

7 years 3 months ago #138501 by tommylight

Replied by tommylight on topic Not moving forward in gcode after m3

Do you have anything with "spindle at speed" in hal ?

Please Log in to join the conversation.

7 years 3 months ago #138588 by phoenix

Replied by phoenix on topic Not moving forward in gcode after m3

No sir it seems not
How can i remove this feed hold
What if i send released feed hold from parport output??

Please Log in to join the conversation.

7 years 3 months ago #138616 by andypugh

Replied by andypugh on topic Not moving forward in gcode after m3

What is FeedHold connected to in HAL?

Please Log in to join the conversation.

7 years 3 months ago #138617 by tommylight

Replied by tommylight on topic Not moving forward in gcode after m3

Connect torch on to arcok signals in hal or on the parallel port.

Please Log in to join the conversation.

Time to create page: 0.102 seconds