Making a thc with resume cut button using thcud

.

@Phoenix,

This is in all the year's i see a moderator deleting a text of a forum member.
Here is your solution for your question :

u are saying i do not need to compile plasmac
then how can i get it ???
or i have to wait for next release ??

I think i would go for debian 9 stretch..

linuxcnc.org/downloads/

Sir i got it from build bot on wheezy thanks for your kind help
Now I'm struggling to make parport connections in that config
I tried loading parellal port using loadrt
But its just not loading parport component

@Phoenix,

I have a idea for you !!

Now I'm struggling to make parport connections in that config
You downloaded and installed a dvd or usb install with linux. On your pc are several configuration's.
It has a parport configurator. Fill in the parport configurator as minimal for you. Test output 17 on your board.

If this work's you can add the parport lines step by step in a other configuration. Does not matter wich configuration.
I can add a parport to a mesa hal file, or to a etercat hal file. In linux you can do everything you want. But it takes time to
investegate.

Take your time. In the end. (after a few years) you got ultimate power !!

Grotius wrote: Take your time. In the end. (after a few years) you got ultimate power !!

That was sooooo ........ hmmmm.....powerfull !