Lathe Tool Zero

More
7 years 3 months ago #139795 by Dinuka_Shehan
Lathe Tool Zero was created by Dinuka_Shehan
How Zero out X and Z axis of linux cnc lathe?

Please Log in to join the conversation.

More
7 years 3 months ago #139810 by Todd Zuercher
Replied by Todd Zuercher on topic Lathe Tool Zero
It can be done with the touch off button (work coordinates) or the tool touch off button (tool offsets), or by using MDI commands to do the same things (read about G10 commands in the G-code section of the manual.)

Please Log in to join the conversation.

More
7 years 3 months ago #139827 by Dinuka_Shehan
Replied by Dinuka_Shehan on topic Lathe Tool Zero
OK,
I will read through and leave a comment if their any difficulties>>>

Please Log in to join the conversation.

More
7 years 3 months ago #139829 by BigJohnT
Replied by BigJohnT on topic Lathe Tool Zero
This may explain touch off with a lathe.

gnipsel.com/linuxcnc/g-code/lathe02.html

JT

Please Log in to join the conversation.

Time to create page: 0.125 seconds
Powered by Kunena Forum