15m Industrial Plasma Cutter

Phill, the issue I experienced today is that your configurator on an upgrade creates a spindle pin for the engraver even if you don't have an engraver. So once he sorts out the permissions, that change will fix the problem until you fix your configurator.

Thanks guys.

I have attached my configs directory

I fixed the permission issue and commented out the line, my simulation now runs as it used to.

Thanks for the help.

rodw wrote: Phill, the issue I experienced today is that your configurator on an upgrade creates a spindle pin for the engraver even if you don't have an engraver. So once he sorts out the permissions, that change will fix the problem until you fix your configurator.

Yes, I broke that, it should have been fixed here

Jarman wrote: I fixed the permission issue and commented out the line, my simulation now runs as it used to.

Thanks for the help.

All good, I was wondering why I saw "twopass:found /usr/share/linuxcnc/hallib/basic_sim.tcl" in your error report.

I didn't realise you where just running sims.

Did you copy the original sim directory and make changes where needed?

phillc54 wrote: Yes, I broke that, it should have been fixed here

How could you ???
:laugh: :laugh: :laugh:

tommylight wrote:

phillc54 wrote: Yes, I broke that, it should have been fixed here

How could you ???
:laugh: :laugh: :laugh:

HaHa, It was really easy to do...

Jarman wrote: my simulation now runs as it used to.

Haven''t you built that machine yet? Its only a tiny one, I thought you'd be able to knock it over in an afternoon ....................... ?

rodw wrote:

Jarman wrote: my simulation now runs as it used to.

Haven''t you built that machine yet? Its only a tiny one, I thought you'd be able to knock it over in an afternoon ....................... ?

HaHa, I thought the same with mine.