Paraport Card randomly stopped connecting

Not sure what happened this morning, but paraport address when starting AXIS reports as not found.

However, when I run stepConfig and use the same address '0xe800'. It works!

However, after launching AXIS from that new setup it kicks back to not being found.

Any ideas? I'm lost. Card was confirmed to work.

Try 0 (zero) instead of address.

Still getting error

"Linux parallel port @59392 not found"

It's strange '0xe800' works in step config. I guess something is wack in my linux distro.

:whistle:

Wow. Realized E-stop wiring was a bit shoddy.

Apparently stepConfig doesn't care if E-stop is positive :blink:

Everything back to normal now! :silly: