thc

More
7 years 2 months ago #142233 by getyers
thc was created by getyers
hi all
anybody who knows something about the ROBOT3T THC3T-2 with stepper and driver controls working on the MACH3 5 AXIS BREAKOUT INTERFACE BOARD, ant info please

george

Please Log in to join the conversation.

More
7 years 2 months ago #142243 by pl7i92
Replied by pl7i92 on topic thc
this driver workes on its own
you simply connect like a standard stepper
DIR STEP
it corrects the THC as the EAGLE THC with steper does

Please Log in to join the conversation.

More
7 years 2 months ago #142246 by getyers
Replied by getyers on topic thc
on the drawing of the robot3t it says arc ok and ground go to to the bob, can you tell me where.

thanks
george

Please Log in to join the conversation.

More
7 years 2 months ago #142247 by getyers
Replied by getyers on topic thc
on the drawing of the robot3t it says arc ok and ground go to to the bob, can you tell me where.

thanks
george

Please Log in to join the conversation.

More
7 years 2 months ago #142269 by tommylight
Replied by tommylight on topic thc
To one of the inputs on the bob.

Please Log in to join the conversation.

More
7 years 2 months ago #142289 by rodw
Replied by rodw on topic thc
I Actually bought one of these but never used it.
There is a manual for it but to big to attach here. I would go back and ask them for it as it has more detailed wiring info

Please Log in to join the conversation.

Time to create page: 0.089 seconds
Powered by Kunena Forum